| Peer-Reviewed

Influence of Loading Speed on Acoustic Emission During Destruction of a Composite by Von Mises Criterion

Received: 12 March 2020     Accepted: 14 April 2020     Published: 31 August 2020
Views:       Downloads:
Abstract

In this study of the composite material’s destruction caused by transverse force with the use of von Mises criterion, the simulation outcomes of the composite material’s cells destruction process and generated AE signals with increasing the strain rate is considered. The time dependencies of the change in the number of remaining elements and the generated AE signals with increasing the strain rate are obtained. Simulation outcomes of the process of composite cells destruction by von Mises criterion and generated acoustic emission signals with increasing strain rate are presented. It was determined that with increasing strain rate of the composite, there is an increase of decline rate of the strain curve of the remaining cells in time and a decrease in time of the destruction process. It was found that with increasing strain rate of the composite, the amplitude of the generated acoustic emission signal increases while its duration decreases, along with gradual transformation of the acoustic emission signal into a triangular signal. It was determined that with increasing strain rate of the composite, the pattern of change in the maximum amplitude of the generated acoustic emission signals has a linear character of increase, and their duration – nonlinear character of decline.

Published in American Journal of Mechanical and Materials Engineering (Volume 4, Issue 3)
DOI 10.11648/j.ajmme.20200403.13
Page(s) 54-59
Creative Commons

This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.

Copyright

Copyright © The Author(s), 2020. Published by Science Publishing Group

Keywords

Composite, Destruction, Acoustic Emission, Threshold Stress, Signal Amplitude, Fracture Criterion, Deformation

References
[1] Bussiba A. Damage evolution and fracture events sequence in various composites by acoustic emission technique /A. Bussiba, M. Kupiec, S. Ifergane, R. Piat, T. Böhlke // Composites Science and Technology. -2008.-vol. 68.-P. 1144-1155.
[2] Nimdum P. Use of acoustic emission to discriminate damage modes in carbon fibre reinforced epoxy laminate during tensile and buckling loading / P. Nimdum, J. Renard // ECCM 15 - 15th European Conference on Composite Materials, Jun 2012, Venise, Italy.- 2012.- 8 p., hal-01109533.
[3] Cluster Analysis of Acoustic Emission Signals for Carbon/Epoxy Composite in Four-Point Bending Test / R. Khamedi, O. Pedram // International Journal of Engineering: TRANSACTIONS C: Aspects.-2015.-vol. 28,-No. 9.-P. 1336-1342.
[4] Ereifej N. S. Fracture of fiber-reinforced composites analyzed via acoustic emission / N. S. Ereifej, Y. G. Oweis, S. K. Altarawneh // Dental Materials Journal.-2015.-vol. 34. No. 4.-P. 417-424.
[5] Fotouhi M. Detection of fibre fracture and ply fragmentation in thin-ply UD carbon/glass hybrid laminates using acoustic emission / M. Fotouhi, P. Suwarta, M. Jalalvand, G. Czel, M. R. Wisnom // Composites: Part A. 2016.-vol. 86,-P. 66-76.
[6] Gholizadeh S. Glass fiber-reinforced polyester composite fatigue crack monitoring using acoustic emission / S. Gholizadeh, Z. Leman, B. Baharudin, O. Innayatullah // International Journal of Advances in Science Engineering and Technology, 2016.-vol. 4. No 2.-P. 100-105.
[7] Godin N. Damage diagnostic and lifetime prognosis for ceramic matrix composite with acoustic emission during long-term mechanical tests at intermediate temperature / N. Godin, P. Reynaud, G. Fantozzi // EWGAE. 33-rd European Conference on Acoustic emission testing (12-14 September, 2018, Senlis, France). -2018.-16 p.
[8] Moure M. M., Sánchez-Sáez S., Barbero E. & Barbero E. J. (2014). Analysis of damage localization in composite laminates using a discrete damage model / M. M. Moure, S. Sánchez-Sáez, E. Barbero, E. J. Barbero // Composites: Part B.-2014.-vol. 66.-P. 224-232.
[9] Barbero E. J. Determination of material parameters for discrete damage mechanics analysis of carbon-epoxy laminates / E. J. Barbero, F. A. Cosso // Composites Part B.-2014.-vol. 56.-P. 638-646.
[10] Jin W. Micromechanics based discrete damage model with multiple non-smooth yield surfaces: Theoretical formulation, numerical implementation and engineering applications / W. Jin, C. Arson // International Journal of Damage Mechanics, 27 (5): 611-639, 2018.
[11] Oliver J. A consistent characteristic length for smeared cracking models / J. Oliver // International Journal for Numerical Methods in Engineering.-1989.-vol. 28.-No 2.-P. 461-474.
[12] Wisnom M. R., Modelling discrete failures in composites with interface elements / M. R. Wisnom // Composites Part A Applied Science and Manufacturing.-2010.-vol. 41.-No. 7.-P. 795-805.
[13] Heinrich C. Investigation of progressive damage and fracture in laminated composites using the smeared crack approach / C. Heinrich, A. M. Waasy // 53rd AIAA/ASME/ASCE/AHS/ASC Structures, Structural Dynamics and Materials Conference (23 - 26 April 2012, Honolulu, Hawaii).-2012.-19 p.
[14] McAuliffe C. A coupled phase field shear band model for ductile brittle transition in notched plate impacts / C. McAuliffe, H. Waisman // Computer Methods in Applied Mechanics and Engineering.-2016.-vol. 305.-P. 173-195.
[15] Bleyer J. Phase-field modelling of anisotropic brittle fracture including several damage mechanisms / J. Bleyer, R. Alessi // Computer Methods in Applied Mechanics and Engineering.-vol. 336.-P. 213–236.
[16] Dzepina B. A phase field model of pressure-assisted sintering / B. Dzepina, D. Balinta, D. Dini // Journal of the European Ceramic Society.-2019.-vol. 39.-P. 173-182.
[17] Newman W. I. Time dependent fiber-bundles with local load sharing / W. I. Newman, S. L. Phoenix // Phys. Rev. E.-2001.-v. 63.-021507.
[18] Turcotte D. L. Micro and macroscopic models of rock fracture / D. L. Turcotte, W. I. Newman, R. Shcherbakov // Geophys. J. Int.-2003.-vol. 152.-P. 718-728.
[19] Kun F. Extension of fibre bundle models for creep rupture and interface failure / F. Kun, R. C. Hidalgo, F. Raischel, H. J. Herrmann // International Journal of Fracture.-2006.-vol. 140.-No 1-4.-P. 255-265.
[20] Swolfs Y. Global load-sharing model for unidirectional hybrid fibre-reinforced composites / Y. Swolfs, R. M. McMeeking, V. P. Rajan, F. W. Zok, I. Verpoest, L. Gorbatikh // Journal of the Mechanics and Physics of Solids. -2015.-vol. 84.-P. 380-394.
[21] Raischel F. A simple beam model for the shear failure of interfaces / F. Raischel, F. Kun, H. J. Herrmann // Phys. Rev. E.-2005.-vol. 72.-P. 046126.
[22] Shcherbakov R. On modeling of geophysical problems: A dissertation for degree of doctor of philosophy / Robert Shcherbakov. - Cornell university, -2002.-209 P.
[23] Filonenko S. Destruction of composite material by shear load and formation of acoustic emission / S. Filonenko, V. Kalita, A. Kosmach // Aviation.-2012.-v. 16.-No 1.-P. 5-13.
[24] Filonenko S. A study to determine the onset of catastrophic wear of a processing tool by statistical parameters of acoustic emission / Stakhova A. // Eastern-European Journal of Enterprise Technologies. 2019.-v. 6, No 9 (102).
Cite This Article
  • APA Style

    Sergii Filonenko, Viacheslav Stadychenko. (2020). Influence of Loading Speed on Acoustic Emission During Destruction of a Composite by Von Mises Criterion. American Journal of Mechanical and Materials Engineering, 4(3), 54-59. https://doi.org/10.11648/j.ajmme.20200403.13

    Copy | Download

    ACS Style

    Sergii Filonenko; Viacheslav Stadychenko. Influence of Loading Speed on Acoustic Emission During Destruction of a Composite by Von Mises Criterion. Am. J. Mech. Mater. Eng. 2020, 4(3), 54-59. doi: 10.11648/j.ajmme.20200403.13

    Copy | Download

    AMA Style

    Sergii Filonenko, Viacheslav Stadychenko. Influence of Loading Speed on Acoustic Emission During Destruction of a Composite by Von Mises Criterion. Am J Mech Mater Eng. 2020;4(3):54-59. doi: 10.11648/j.ajmme.20200403.13

    Copy | Download

  • @article{10.11648/j.ajmme.20200403.13,
      author = {Sergii Filonenko and Viacheslav Stadychenko},
      title = {Influence of Loading Speed on Acoustic Emission During Destruction of a Composite by Von Mises Criterion},
      journal = {American Journal of Mechanical and Materials Engineering},
      volume = {4},
      number = {3},
      pages = {54-59},
      doi = {10.11648/j.ajmme.20200403.13},
      url = {https://doi.org/10.11648/j.ajmme.20200403.13},
      eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.ajmme.20200403.13},
      abstract = {In this study of the composite material’s destruction caused by transverse force with the use of von Mises criterion, the simulation outcomes of the composite material’s cells destruction process and generated AE signals with increasing the strain rate is considered. The time dependencies of the change in the number of remaining elements and the generated AE signals with increasing the strain rate are obtained. Simulation outcomes of the process of composite cells destruction by von Mises criterion and generated acoustic emission signals with increasing strain rate are presented. It was determined that with increasing strain rate of the composite, there is an increase of decline rate of the strain curve of the remaining cells in time and a decrease in time of the destruction process. It was found that with increasing strain rate of the composite, the amplitude of the generated acoustic emission signal increases while its duration decreases, along with gradual transformation of the acoustic emission signal into a triangular signal. It was determined that with increasing strain rate of the composite, the pattern of change in the maximum amplitude of the generated acoustic emission signals has a linear character of increase, and their duration – nonlinear character of decline.},
     year = {2020}
    }
    

    Copy | Download

  • TY  - JOUR
    T1  - Influence of Loading Speed on Acoustic Emission During Destruction of a Composite by Von Mises Criterion
    AU  - Sergii Filonenko
    AU  - Viacheslav Stadychenko
    Y1  - 2020/08/31
    PY  - 2020
    N1  - https://doi.org/10.11648/j.ajmme.20200403.13
    DO  - 10.11648/j.ajmme.20200403.13
    T2  - American Journal of Mechanical and Materials Engineering
    JF  - American Journal of Mechanical and Materials Engineering
    JO  - American Journal of Mechanical and Materials Engineering
    SP  - 54
    EP  - 59
    PB  - Science Publishing Group
    SN  - 2639-9652
    UR  - https://doi.org/10.11648/j.ajmme.20200403.13
    AB  - In this study of the composite material’s destruction caused by transverse force with the use of von Mises criterion, the simulation outcomes of the composite material’s cells destruction process and generated AE signals with increasing the strain rate is considered. The time dependencies of the change in the number of remaining elements and the generated AE signals with increasing the strain rate are obtained. Simulation outcomes of the process of composite cells destruction by von Mises criterion and generated acoustic emission signals with increasing strain rate are presented. It was determined that with increasing strain rate of the composite, there is an increase of decline rate of the strain curve of the remaining cells in time and a decrease in time of the destruction process. It was found that with increasing strain rate of the composite, the amplitude of the generated acoustic emission signal increases while its duration decreases, along with gradual transformation of the acoustic emission signal into a triangular signal. It was determined that with increasing strain rate of the composite, the pattern of change in the maximum amplitude of the generated acoustic emission signals has a linear character of increase, and their duration – nonlinear character of decline.
    VL  - 4
    IS  - 3
    ER  - 

    Copy | Download

Author Information
  • Department of Computerized Electrical Systems and Technology, Aerospace Faculty, National Aviation University, Kyiv, Ukraine

  • Department of Hydro-Gas Systems, Aerospace Faculty, National Aviation University, Kyiv, Ukraine

  • Sections